Locate a switched 12VDC power source (on/off with ignition).
Identify your motorcycle's color code for power, ground, turn signals and brake signal wires.
Note: if you plan to install the output to an auxiliary light(s), disregard the turn signal wires mentioned above.
Select a clean surface on a motorcycle to install VoloMOD.
All connectors for full installatios are included with VoloMOD
Connect VoloMOD black wire (#4) to the motorcycle's ground using the posi-tap connector.
Connect VoloMOD red wire (#5) to the motorcycle's switched 12V using the posi-tap connector.
Instructions on how to use posi-tap connectors can be found here.
Once installed, switch the motorcycle to the ON position and check for the start up sequence shown in the video.
Make sure motorcycle is OFF.
The longer solid blue and brown wires from the VoloMOD are the output wires.
The shorter blue and brown wires with white strips from the VoloMOD are inputs to the VoloMOD.
Instructions on how to use Posi-lok connectors can be found here.
Identify the turn signals wires and cut them in two
Make connections as shown in the schematic.
Check the output connection by tilting VoloMOD slowly until the first trigger point is met; and then the second as shown in the video
Check both the LEDs on the VoloMOD and your brake lights
Remove velcro backing and place velcro on the surface
IMPORTANT! Ensure that the arrow is pointing towards the front of the motorcycle
Surface grade should be less than 45 degrees. Avoid "negative slope" i.e sloping back towards the motorcycle
There are three sensitivity settings on the VoloMOD
This step is optional. To change the setting, click here.
The default setting, 1.5 m/s^2 or 3.35 mph/s and is recommended for most motorcycles.
The Touring settings, 1 m.s^2 or 2.24 mph/s and is recommended for larger motorcycles.
The Sports settings, 2 m/s^2 or 4.5 mph/s and is recommended for high compression sports motorcycles.
IMPORTANT: Calibration must be performed on a level surface with the motorcycle in an upright position.
With the power ON, introduce the magnet to VoloMOD. Note the flash sequence
Remove magnet at the first flash while keeping motorcycle upright and still for 5 seconds.
Note the flash sequence shown in the video.
Remove exposed copper from unused wires and tape together securely.
We recommend riding with a friend to confirm VoloMOD is functioning and calibrated properly.