Triumph Trophy SE
- Author: Faizal Ali
- Time estimate: 30 minutes
- Difficulty: Moderate
The following instructions helps Triumph Trophy owners find and connect a convenient place to pull 12V. Please review the Vololights Manual for complete installation instructions.
Step 1 — Drill a small hole on the rear fender. (5/32") ¶
-
The rear fender has a liner that stops a few inches short of the bottom end of the fender
-
The wires are just long enough to reach so the hole should be 7/8” above a line drawn through the centers of the two license plate mounting bolts.
Step 2 — Run the wire ¶
-
Remove the tail light assembly (owner’s manual p. 160).
-
Run the wire up between the fender and liner
-
The wire can be fed through a large hole into the light assembly (See image 2)
-
Use the Posi-taps to hook into the existing license plate light illumination power.
0 Comments
Add a commentNo comments.